Hp Integrity NonStop H-Series Uživatelský manuál stáhnout pdf (Strana 29)

9840 (CT9840FC-3) Installation and User’s Guide for the NonStop S-Series Enclosure—524959-003

2-1

2 Installing the Tape Drive

This section includes:

Overview

Because the tape drives are shipped already in the tape enclosure, minimal

installation is involved unless you need to install spare drives in the enclosure.

Refer to Servicing the Tape Drive

on page 6-1 for instruction on installing or

removing a tape drive.

Attaching the Power Cord

1. Check that the power switch on the tape drive is set to 0 (OFF). See

Figure 2-1.

2. Connect the power cord to the tape drive’s AC power receptacle.

3. Make sure the connector is fully seated.

Overview 2-1

Attaching the Power Cord 2-1

Installing the SCSI Interface Cable 2-2

Installing Multimode Fiber Cables 2-3

Powering On the Tape Drive and the Fibre

Channel Converter

2-4

Installing the Rear Cover 2-5

Note. Do not attach the male end of the power cord to a power outlet at this time.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 85 86

Žádné komentáře

Hp Integrity NonStop H-Series Uživatelský manuál Strana 29