Hp Netserver E Server series Uživatelský manuál stáhnout pdf (Strana 44)

Chapter 5 Troubleshooting

5. Turn off power to the NetServer.

6. Return switch 7 on the system board to the open position.

7. Replace the cooling duct/cover and the NetServer cover.

8. Turn on power to the NetServer and allow it to complete its startup

routine.

9. If you wish to set passwords again, after the power-on system hardware

test has completed, press [F2] to start the Setup program.

10. Set the new password(s).

11. Choose the Exit option and save the changes to save the new password(s).

Battery Problems

If your HP NetServer repeatedly loses its configuration or the CPU clock stops,

you should replace the battery or install an external battery (an external battery

with a 5 year lifespan is available from HP, order 1420-0513 from your

authorized reseller.)

WARNING There is a danger of explosion if the battery is incorrectly

installed. For your safety, never attempt to recharge,

disassemble, or burn the old battery. Replace only with the

same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer’s

instructions.

To Install a Replacement Battery

1. Turn off power to the NetServer.

2. Remove the NetServer cover and the cooling duct/cover.

3. Remove the existing battery.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 96 97

Žádné komentáře

Hp Netserver E Server series Uživatelský manuál Strana 44