Hp Netserver L Server series Uživatelský manuál stáhnout pdf (Strana 40)

Chapter 6 Installing Mass Storage Devices

Installing a Hot-Swap Hard Disk Drive

CAUTION Protect the drive from static electricity by leaving it in its

anti-static bag until you are ready to install it. Before

handling the drive, touch any unpainted metal surface to

discharge static electricity. When you remove the drive from

the anti-static bag, handle it only by the frame.

Do not touch the electrical components. Place the drive on

the anti-static bag whenever you set it down.

Hard disk drives are very susceptible to mechanical shock and

can be damaged by a drop as short as one-quarter of an inch.

Take care when unpacking and handling the drive. If the

drop would crack an egg, it will damage the drive.

1. If there is a filler panel in the hot-swap mass storage location, remove the

filler as follows:

• Press the locking latch and insert your fingers.

• Using your fingers, pull the filler panel straight out.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 153 154

Žádné komentáře

Hp Netserver L Server series Uživatelský manuál Strana 40