Hp ProLiant DL380 Server Uživatelský manuál stáhnout pdf (Strana 52)

Hardware options installation 52

Install the DIMM.

8. Install the access panel (on page 23).

9. Install the server into the rack ("Installing the server into the rack" on page 35).

10. Connect each power cord to the server.

11. Connect each power cord to the power source.

12. Power up the server (on page 21).

Use RBSU ("HP ROM-Based Setup Utility" on page 94) to configure the memory mode.

For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display LED

combinations (on page 11)."

Hot-plug hard drive options

When adding hard drives to the server, observe the following general guidelines:

• The system automatically sets all device numbers.

• If only one hard drive is used, install it in the bay with the lowest device number.

• Drives should be the same capacity to provide the greatest storage space efficiency when drives are

grouped together into the same drive array.

Installing a hot-plug SAS or SATA hard drive

The server can support 8 SAS or SATA hard drives in a SFF or LFF configuration, or 16 drives in a SFF

configuration with the optional hard drive cage ("Hard drive cage option" on page 68).

To install the component:

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 127 128

Žádné komentáře

Hp ProLiant DL380 Server Uživatelský manuál Strana 52