HP TippingPoint Next Generation Firewall Series Instalační manuál stáhnout pdf (Strana 33)

Next Generation Firewall Hardware Specification and Installation Guide 21

5 Installing the NGFW Appliance

After you have completed preparation procedures and unpacked the HP TippingPoint NGFW Appliance,

you are ready to install and configure the components. Have the CLI Reference available for configuration

information reference. After installation of the hardware components, complete the OBE Setup Wizard

requirements as part of the installation and configuration procedures.

NOTE: Before installing your NGFW Appliance, review and adhere to all safety guidelines described the

Hardware Safety and Compliance Guide, which also contains detailed regulatory compliance information

and is included with your product shipment.

This information includes the following procedures:

•”Install the Chassis” on page 21

•”Attach Cables” on page 26

•”Check LEDs” on page 27

•”Setup Wizard” on page 27

Install the Chassis

Before installing your new NFGFW Appliance, gather any necessary materials and prepare the network

and hardware site. To carefully and correctly install the appliance, read through all preparation instructions

and requirements. This information provides general guideline information for all TippingPoint appliances.

To install the appliance you must do the following:

•”Determine Total Rack Space” on page 21

•”Attach the Appliance to the Rack” on page 21

•”Connect the Power Supply” on page 26

Determine Total Rack Space

Before you install the chassis, determine the total rack space that is required to install your system. The total

required rack space increases if you plan to install multiple systems.

The NGFW Appliance fits in a 19-inch-wide rack (or a 23-inch-wide rack, with appropriate conversion

parts available from rack accessory vendors). For more information about the dimensions of the appliance,

refer to the technical specifications and requirements for your model.

Attach the Appliance to the Rack

The NGFW S1000 Series appliance ships with a four-post rack-mount kit to mount the appliance to a rack.

You can use this kit to install the appliance in a two-post or four-post rack.

The S3000 Series and S8000 Series appliances ship with a slide rail kit to mount these appliances to a

four-post rack and mounting ears for two-post racks. Slide rail kits are also available for order from

TippingPoint. Refer to the instructions in the slide rail kit for information about installing the slide rails.

For two-post racks, use the front mounting ears to install S3000 Series and S8000 Series appliances in

either front-mount or mid-mount positions.

Your NGFW Appliance shipment includes the following mounting hardware:

• Front-mounting brackets for a 19-inch rack. Adapters (available from rack accessory vendors) are

required for posting in a 23-inch rack.

• Rear-mounting brackets for the NGFW S1000 Series appliance in a 19-inch rack. Adapters (not

included) are required for posting in a 23-inch rack.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 53 54

Žádné komentáře

HP TippingPoint Next Generation Firewall Series Instalační manuál Strana 33