HP 10BASE-T Uživatelská příručka stáhnout pdf (Strana 33)

5. Connect the Hub to the Distributed

Management Console (optional)

The HP AdvanceStack hubs can be controlled in two ways:

from a PC running the HP Stack Manager software that is supplied

with the hubs

from an ASCII terminal or PC running a terminal emulation (requires

an HP Ethernet SNMP Module to be installed in the hub or in one of

the hubs in the distributed management chain)

The PC serves as a console for an out-of-band management session that

enables you to configure, monitor, and diagnose one hub or a stack of up

to 16 hubs that are chained together. The HP Stack Manager software is

described in chapter 2, “Installing and Using HP Stack Manager”.

With the HP Ethernet SNMP Module, the module’s console is also used

to configure, monitor, and diagnose one hub or a stack of up to 16 hubs

that are chained together. You can access the console through a terminal

emulator on your PC or through a terminal.

There are three ways to access a hub:

through a direct serial connection

through a modem connection (available for HP Stack Manager or

ASCII terminal only if an HP J6203 Ethernet SNMP Module is

installed in the hub to which the modem is connected)

through the distributed management chain

Installing the

HP AdvanceStack Hubs

Installing the HP AdvanceStack 10Base-T Hubs

1-20

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 135 136

Žádné komentáře

HP 10BASE-T Uživatelská příručka Strana 33