HP 10BASE-T Uživatelská příručka Strana 74

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 136
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 73
LED patterns indicating problems Diagnostic Tips
Power Collision Fault Security RPS Exp
Slot
Port
ON * Slow
Flash
OFF * * Slow
Flash
The port has been auto-segmented because of too
many collisions. Check cable terminations,
connections, SQE setting on any external
transceivers, and status of attached network devices
for causes of the excess collisions.
ON * Slow
Flash
*Slow
Flash
**
The redundant power supply (RPS) may no longer be
providing redundant power. See the documentation
provided with the RPS for troubleshooting.
OFF * * * OFF * *
The hub is not receiving power from the redundant
power supply (RPS) or the cable connection is loose.
If you have an RPS connected, check the cable
connections.
ON * * Rapid
Flash
* ON Rapid
Flash
A port security violation has occurred on a hub with
an HP Ethernet SNMP Module. The port is disabled.
Port security parameters are configurable from
HP Interconnect Manager. See the documentation
for that program for more information.
ON * * Rapid
Flash
*ONNot
Flashing
An unauthorized network management station has
attempted to access a hub with an HP Ethernet
SNMP Module.
ON * ON ON * Slow
Flash
(for
more
than 60
sec.
after a
reset
or
power
on)
All ON
The HP Ethernet SNMP Module has failed self-test
and/or its firmware code has become corrupted. This
is frequently the result of a failure during
downloading of new code. Repeat the download
process.
If the hub self-test fails again, contact your
HP-authorized LAN dealer or HP representative for
assistance.
Under this condition, the hub will continue its normal
repeater function, but the console and control
capabilities will be limited.
ON * ON ON * ON Variable;
all may
be ON
A hub hardware failure was detected during self-
test. Self-test does not complete so the LEDs will
stay on longer than 60 seconds.
Power cycle the hub. If this condition persists, the
hub may have to be replaced. Contact your
HP-authorized LAN dealer or HP representative for
assistance.
* This LED is not important for the diagnosis
Troubleshooting
Troubleshooting
4-5
Zobrazit stránku 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 135 136

Komentáře k této Příručce

Žádné komentáře