HP 8800 Router Series Instalační manuál stáhnout pdf (Strana 64)

Figure 42 Replacing a CF card

Replacing a transceiver module

CAUTION:

hen installin

or removin

an SFP transceiver module, do not touch the

olden fin

er.

The replacement procedures for XFP and SFP transceiver modules are similar. This section uses an SFP

transceiver module as an example.

To replace a transceiver module:

1. Put on an ESD-preventive wrist strap, ensuring that the wrist strap makes good skin contact and

is grounded.

2. Remove the optical fibers from the SFP transceiver module, pivot the clasp down to the

horizontal position, and then pull SFP the transceiver module out of the socket as shown

in Figure 43.

3. Put the removed SFP transceiver module in an antistatic bag or its original shipping materials.

4. Unpack a new SFP transceiver module, pivot the clasp of the SFP transceiver module upward to

the vertical position so that it catches a knob on the top of the SFP transceiver module, and then,

holding both sides of the SFP transceiver module, gently push the SFP transceiver module into

the socket until it has close contact with the socket (you can feel that the top and bottom spring

tabs catch in the socket), as shown in Figure 44.

5. Connect the optical fibers to the new SFP transceiver module.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 120 121

Žádné komentáře

HP 8800 Router Series Instalační manuál Strana 64