HP LCS60 Uživatelský manuál Strana 105

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 432
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 104
LCS60 Software
Configure Default Route, DNS, and SNMP
IP address of SNMP manager for community "traps" [?, q]
==> 154.12.21.2
Access right for SNMP manager "154.12.21.2" [r, w, t, ?, q]
==> t
Adding the following information to the configuration file:
community traps 154.12.21.2 traps
Confirm? [y, n] y
Enter Community Name [?, q]
==> q
Top>Config> #
Note: Supported traps are listed in Chapter 1. Refer to RFC1213 for supported
MIBs.
Be sure to specify routed and snmp with the protocol command to start SNMP
service at boot time.
Starting the LCS60
After configuring the LCS60, you must start the protocols and services you have
configured using the start all command from the Top directory of lcsadm.
Base Level Backup
Once the LCS60 is installed and configured, the administrator should make a
complete set of backup tapes of the LCS60 variable files to preserve the confi-
guration information. These tapes can be labeled "day 0 backups" and can be
used to restore the LCS60 quickly to a working state if necessary. Use the com-
mand lcsadm -c config backup as described in Chapter 8.
Issue 3 3-27
Zobrazit stránku 104
1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 431 432

Komentáře k této Příručce

Žádné komentáře