HP ProCurve 800 Network Access Controller series Instalační manuál stáhnout pdf (Strana 21)

2-13

Quick Install

Installing the Appliance

Quick Install

b. To move to the next number in the entry, press the X button to move

right, or the

W button to move left. Press once for each number space

you want to move. The underscore ( _ ) indicates the selected number.

c. When the IP address is set correctly, press the

3 button to apply the

new IP address, and continue to the Subnet Mask configuration.

2. To change the Subnet Mask entry, use the same procedure described in

steps a. and b. above.

When the Subnet Mask is set correctly, press the

3 button to apply the

new entry, and continue to the Default Gateway configuration.

3. To change the Gateway entry, use the same procedure described in steps

a. and b. above, then press the 3 button to apply the new entry, and

continue.

4. The IP address is verified and a confirmation message displays if it is

configured correctly.

After five seconds, the Configuration menu displays again.

If any part of the address is misconfigured, an error message displays.

After five seconds the display returns to the point where the first

misconfiguration was detected.

Repeat the process for setting the IP address, Subnet Mask, and Gateway

until the address is verified.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Žádné komentáře

HP ProCurve 800 Network Access Controller series Instalační manuál Strana 21