HP J Class 3 - For Visualization Center Servisní příručka stáhnout pdf (Strana 104)

104 Chapter5

Boot Console Handler

Accessing the Boot Console Handler

To access the Boot Console Handler, follow these steps:

1. Close any ﬁles and applications on the workstation.

2. Press the power switch on the front panel of the workstation to power it off.

NOTE There is no need to manually shut down the HP-UX operating system on the

workstation before powering it off. When you press the power switch, the

workstation automatically shuts down the operating system before

terminating the power.

Make sure you do not unplug the workstation’s power cord or otherwise interrupt power

to the workstation at this time.

3. Power on the workstation after the system has completely shut down.

If auto boot is turned off, the boot sequence automatically stops at the boot console

Main Menu.

If auto boot is turned on, you will see the following message:

Processor is starting auto boot process. To discontinue, press any key

within 10 seconds.

If auto boot and auto search are both turned on, you will see the following message:

Processor is booting from first available device. To discontinue, press

any key within 10 seconds.

NOTE If you are using a power-saving monitor, you will have less than 10 seconds

from the time this message appears to press a key.

4. Press a key. You will then see the following message:

Boot terminated

The Main Menu of the Boot Console Handler appears.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 147 148

Žádné komentáře

HP J Class 3 - For Visualization Center Servisní příručka Strana 104