HP J Class 3 - For Visualization Center Servisní příručka stáhnout pdf (Strana 21)

Chapter 1 21

Product Information

Front Panel Components

Step 5

• Attach the new disk to the active volume group with the vgchange command.

vgchange -a y /dev/vg00

Step 6

• If the disk is not a mirror of a root disk, then skip this step.

• Run the mkboot command. For example:

mkboot /dev/rdsk/c2t5d0

• Run lvlnboot -R to relink the replaced disk into the Boot Data Reserved Area of all

the Physical volumes in the Volume group.

lvlnboot -R

Step 7

• Run the lvsync command to synchronize the physical extents of each logical volume

speciﬁed by logical volume path. Synchronization occurs only on physical extents that

are stale mirrors of the original logical extent.

lvsync /dev/<volume group name>/<

LV name

For example:

lvsync /dev/vg00/stand

lvsync /dev/vg00/swap

lvsync /dev/vg00/

At this stage, your system should be fully functioning. Use the xstm command to verify.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 147 148

Žádné komentáře

HP J Class 3 - For Visualization Center Servisní příručka Strana 21