HP NetServer LP 2000r Uživatelská příručka stáhnout pdf (Strana 111)

Chapter 12 Troubleshooting

105

Replacing a Battery

If your HP Netserver repeatedly loses its configuration or the processor clock

stops, you should replace the battery.

WARNING There is danger of explosion if the battery is incorrectly

installed. For your safety, never attempt to recharge,

disassemble, or burn the old battery. Replace only with the

same or equivalent type recommended by the manufacturer.

Dispose of used batteries according to the manufacturer’s

instructions.

1. Power down the HP Netserver and unplug power cord.

2. Extend the Netserver out from the rack.

3. Remove the Netserver cover and the air flow guide. Refer to

Chapter 2, "Opening and Closing the HP Netserver."

4. Remove the PCI card cage. Refer to Chapter 2.

5. Insert a small flatblade screwdriver or similar tool between the battery and

spring latch. See Figure 12-3.

6. Push the spring latch away from battery to release the battery and then

remove the battery.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 135 136

Žádné komentáře

HP NetServer LP 2000r Uživatelská příručka Strana 111