HP Omni 220-1155xt CTO Desktop PC Uživatelský manuál

Wall-Mounting your HP computerUser Guide

8. Push the hinge cover down to remove it from the stand.9. Push the hinge cover into place at the back of the computer.6 Chapter 1 Preparing your H

10. Install the screw to secure the hinge cover to the back of the computer.11. Replace the back cover on the computer. Press the cover so it snaps in

12. Tighten the two screws at the bottom of the computer to secure the back cover to the computer.If present, tighten the screw (1) at the center of t

2 Reinstalling the stand on yourHP computerYou may decide to convert your computer from a wall-mounted unit back to a desktop unit. You willneed to in

3. After the system has completely shut down, disconnect the power adapter from the back of thecomputer.4. Disconnect all other attached cables from t

2. Remove the back cover by lifting from the I/O area first, and then lifting all the way around thecomputer.3. Remove the screw that secures the hing

4. Replace the hinge cover on the stand by sliding it up into place, aligning the screw holes on thehinge cover with the screw holes on the stand.5. I

6. Place the stand on the back of the computer, inserting the two tabs at the top of the stand intothe two slots on the computer. Align the four screw

8. Replace the back cover on the computer. Press the cover so it snaps into place, and ensure thatthere are no gaps between the computer and the cover

10. Install the VESA cover on the back of the computer.11. Place the computer in an upright position.12. Connect the power cord.13. Connect any cables

The only warranties for Hewlett-Packardproducts and services are set forth in theexpress statements accompanying suchproducts and services. Nothing he

Table of contents1 Preparing your HP computer for wall-mounting ...

iv

1 Preparing your HP computer for wall-mountingThis document provides instructions for computer wall-mounting preparation. The VESA assembly isat the b

Before removing the standTo avoid injury and equipment damage when opening the computer, always complete the followingsteps in order:1. Remove any med

2. Remove the VESA cover at the back of the computer by inserting your finger in the slot andlifting the cover off.3. Loosen the two screws at the bot

4. Remove the back cover by lifting from the I/O area first, and then lifting all the way around thecomputer.5. Remove the four screws (1, 2, 3, and 4

6. To remove the stand, lift it forward toward the top of the computer and then lift it off.7. Remove the two screws securing the hinge cover to the s