HP Visualize c240 - Workstation Servisní příručka stáhnout pdf (Strana 140)

124

Changing Your Workstation’s Hardware Conﬁguration

Replacing the Main Tray Assembly

Perform the following steps to replace the main tray assembly:

1 Align the main tray assembly with the chassis and slide it into place, as shown in

Figure 39.

Figure 39 Replacing the Main Tray Assembly

2 Slide the main tray in until you feel it make contact with the internal connectors.

3 Push firmly and evenly on the main tray assembly to make sure that all connec-

tors are fully seated.

4 Start all five thumb screws loosely, then tighten them firmly. See Figure 39.

NOTICE: To maintain FCC/EMI compliance, verify that the main tray is fully seated

and all four thumb screws are completely tightened.

Thumb Screws

Thumb

Screws

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 239 240

Žádné komentáře

HP Visualize c240 - Workstation Servisní příručka Strana 140