HP Visualize c240 - Workstation Servisní příručka stáhnout pdf (Strana 148)

132

Changing Your Workstation’s Hardware Conﬁguration

Installing the EGRAM (Enhanced Graphics RAM) Module (C160/C180)

5 Install the standoffs into the EGRAM module, as shown in Figure 44. Push the

standoffs into the holes on the module until the clips fully emgage with the board.

6 Align the connector on the EGRAM module with the connector on the I/O board,

while aligning the standoffs with the holes in the I/O board. See Figure 44.

Figure 44 Installing the EGRAM Module

7 Connect the EGRAM module to the I/O board. Push down firmly on the connec-

tor area to make sure it is fully seated. Push firmly near the standoffs to make sure

that they are fully engaged with the I/O board.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 239 240

Žádné komentáře

HP Visualize c240 - Workstation Servisní příručka Strana 148