HP PCL 5 Uživatelský manuál Strana 155

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 286
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 154
EN Raster Graphics 6-35
End Raster Graphics Command
The End Raster Graphics command signifies the end of a raster
graphic data transfer.
? * r C
Receipt of this command causes 5 operations:
Resets the raster compression seed row to zeros.
Moves the cursor to the raster row immediately following the
end of the raster area (if a source raster height was specified).
Allows raster commands which were previously locked out to
be processed.
Sets compression mode to 0 (no compression).
Defaults the left graphics margin to X-position 0.
Note This command is a modified version of the ?*rB End Raster
Graphics command. The newer version (
?*rC) performs two
additional operations: it resets the compression mode to 0 and
defaults the left graphics margin to 0.
This command (
?*rC) is not supported by the HP LaserJet III or the
HP LaserJet IIID printers. Use the
?*rB End Raster Graphics
command to terminate raster graphic data transfers for these printers.
Refer to the “PCL Feature Support Matrix” in Chapter 1 of the PCL 5
Comparison Guide for specific printers which support these
commands.
Zobrazit stránku 154
1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 285 286

Komentáře k této Příručce

Žádné komentáře