HP SuperStack Firewall Series Uživatelský manuál Strana 141

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 214
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 140
10
C
ONFIGURING
H
IGH
A
VAILABILITY
This chapter describes the commands and options available in the High
Availability menu. The menu is broken up into sections shown in the user
interface as tabs.
To access a command click on High Availability on the left hand side of
the screen and then on the appropriate tab.
This following sections are covered in this chapter:
Getting Started
Configuring High Availability
Making Configuration Changes
Checking High Availability Status
Forcing Transitions
Getting Started The High Availability function allows you to connect two Firewalls
together as a pair. Although only one Firewall will function at a time the
second will automatically take over from the first in the event of a failure.
Before attempting to configure two Firewalls as a High Availability pair,
check the following requirements:
You have two Superstack 3 Firewalls available. The Firewalls must be
running the same version of firmware which must be version 6.0 or
above.
The 3Com Firewalls 3CR16110-95 and 3CR16110-97 use identical
hardware and can be used as a high availability pair provided that they
are using the same version of firmware.
YouhaveatleastonestaticIPaddressavailablefromyourInternet
Service Provider (ISP). If you intend to remotely manage both the
DUA1611-0AAA02.book Page 141 Thursday, August 2, 2001 4:01 PM
Zobrazit stránku 140
1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 213 214

Komentáře k této Příručce

Žádné komentáře