HP Z200 Specifikace stáhnout pdf (Strana 118)

3. Remove four isolation grommet screws from the chassis and install them on the hard drive as

shown in the following figure.

Figure 5-37 Installing the grommet screws

4. Push the hard disk drive into the selected bay until it snaps into place (1) as shown in the following

figure.

Figure 5-38 Installing the HDD drive

5. Attach a power cable (2) to the drive.

6. Attach a data cable (3) from the SATA port controller connectors on the system board.

NOTE: HP recommends using SATA ports 3 and 4 for optical disk drives, ports 0–2 for hard disk

drives, and port 5 only after all other ports have been used. (Refer to the service label on the side

access panel of your computer to determine the location of the SATA ports. These ports are also

shown in Figure 5–1.)

NOTE: All SATA ports are eSATA compatible, even though only one port is labeled for eSATA

on the system board.

7. Replace all components that were removed in preparation for component installation.

8. After you reassemble your system, you can use the Computer Setup (F10) Utility to change the

drive letters and boot order. See

The Computer Setup (F10) Utility on page 29.

106 Chapter 5 Replacing components ENWW

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 191 192

Žádné komentáře

HP Z200 Specifikace Strana 118