Hp OneView for VMware vCenter Uživatelský manuál Strana 60

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 99
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 59
Viewing the audit log
The Storage Module for vCenter provides an audit log for provisioning operations. The audit log,
provisionAuditLog.txt, is available in the following directory:
install directory/Storage/JBoss/standalone/log.
Adding a new datastore
You can add a new datastore to a host or cluster that meets the following prerequisites.
Hosts
The host must exist in the vSphere Client.
In an FC environment, the SAN must be zoned between the storage pools and the host.
The host must be configured as a hostgroup or host on the array.
P4000 arrays in an iSCSI environment only:
The iSCSI initiator on the host must be installed and configured.
The iSCSI array IP address or hostname must be configured in the iSCSI initiator's dynamic
discovery list on the host.
Clusters
The cluster and its hosts must exist in the vSphere Client.
In an FC environment, the SAN must be zoned between the storage pools and the cluster
hosts.
The cluster hosts must be configured as hostgroups or hosts on the array.
The cluster hosts can belong to separate hostgroups.
NOTE: The Storage Module for vCenter does not support configurations that have all cluster
hosts in a single hostgroup.
P4000 arrays in an iSCSI environment only:
The iSCSI initiator on all cluster hosts must be installed and configured.
The iSCSI array IP address or hostname must be configured in the iSCSI initiator's dynamic
discovery list on all cluster hosts.
Adding a datastore
To add a datastore to a host or cluster:
1. Start the vSphere Client.
2. Use one of the following methods to start the Add Datastore wizard:
Right-click a host or cluster and select HP Insight ManagementCreate Datastore.
Select ActionsCreate Datastore on the HP Insight Management page for a host or cluster.
Right-click a host or cluster in any Storage Module for vCenter table, and then select
Create Datastore.
The Add Datastores – Specify Storage window opens. See Figure 30 (page 61).
60 Provisioning storage
Zobrazit stránku 59
1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 98 99

Komentáře k této Příručce

Žádné komentáře