HP PROCURVE 2520 Uživatelský manuál stáhnout pdf (Strana 311)

100

101

Configuring for Network Management Applications

Using SNMP Tools To Manage the Switch

SNMPv1 and SNMPv2c Traps

The switches covered in this guide support the following functionality from

earlier SNMP versions (SNMPv1 and SNMPv2c):

■ Trap receivers: A trap receiver is a management station to which the

switch sends SNMP traps and (optionally) event log messages sent from

the switch. From the CLI you can configure up to ten SNMP trap receivers

to receive SNMP traps from the switch.

■ Fixed or “Well-Known” Traps: A switch automatically sends fixed traps

(such as “coldStart”, “warmStart”, “linkDown”, and “linkUp”) to trap

receivers using a public or non-public community name.

■ Thresholds: A switch automatically sends all messages created when a

system threshold is reached to the network management station that

configured the threshold, regardless of the trap receiver configuration.

Configuring an SNMP Trap Receiver

Use the snmp-server host command to configure a trap receiver that can receive

SNMPv1 and SNMPv2c traps, and (optionally) event log messages. When you

configure a trap receiver, you specify its community membership,

management station IP address, and (optionally) the type of event log

messages to be sent.

If you specify a community name that does not exist—that is, has not yet been

configured on the switch—the switch still accepts the trap receiver

assignment. However, no traps will be sent to that trap receiver until the

community to which it belongs has been configured on the switch.

13-19

1 2 ... 306 307 308 309 310 311 312 313 314 315 316 ... 543 544

Komentáře k této Příručce

Žádné komentáře

HP PROCURVE 2520 Uživatelský manuál Strana 311

Komentáře k této Příručce

Související produkty a manuály pro Software HP PROCURVE 2520