HP Remote Graphics Software (RGS) Uživatelský manuál stáhnout pdf (Strana 149)

another Remote Computer on page 131). The USB devices will be detached from the current computer

and attached to the selected computer.

Figure 6-18 Dynamically moving USB devices to another Remote Computer

6.5.3 Local/Remote USB Device Management

In addition to the general default settings for remote USB configurations, RGS 5.2.6 and higher

releases support auto-remote and auto-return of user-specified USB devices when using Windows on

both the Sender and Receiver platforms. RGS 5.4.0 introduced a new auto-remote configuration syntax

for the Windows Registry entries. Auto-remote allows specified USB devices to be automatically

attached to a remote Sender session at RGS connection and then returned to the local client at RGS

disconnect.

CAUTION: Enabling auto-remoting of specific USB devices requires modifications to the Windows

Registry. Registry modifications should only be made by experienced personnel. Because an incorrect

Registry setting can cause serious problems, you should always make a backup of the Registry prior to

making any changes.

To specify auto-remoting of a particular USB device, perform the following steps:

1. Get the vendor id and device id for your usb device using the following steps. For this example

assume that you found the vendor id is 0x1234 and device id is 0x5678.

a. Open Device Manager and find the USB device to be auto-remoted.

b. Right click the USB device and select Properties.

c. Select the Details tab and select Hardware Ids in the dropdown menu. The Hardware Ids

format will be:

USB\Vid_xxxx&Pid yyyy

ENWW

Remote USB operation

131

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 258 259

Žádné komentáře

HP Remote Graphics Software (RGS) Uživatelský manuál Strana 149