HP Remote Graphics Software (RGS) Uživatelský manuál stáhnout pdf (Strana 105)

Figure 4-4 Advanced Settings dialog

The arrows to the right of the Connections box in Figure 4-4 Advanced Settings dialog

on page 89 can be used to change the order of the network interfaces and, therefore, which

network interface will be used by the RGS Sender. In the above example, the RGS Sender will use

Local Area Connection 3 with an IP address of 10.10.42.59.

To establish a connection from the RGS Receiver to the blade workstation, enter a hostname or IP

address in the HP Remote Graphics Receiver box. If you enter a hostname instead of an IP

address, it is possible the hostname will resolve to the IP address of an incorrect network interface.

This could be caused by a number of factors, including how your DHCP and DNS servers are

configured.

If the hostname resolves to the IP address of an incorrect network interface, you can either:

●

Enter the network interface IP address (instead of hostname) in the HP Remote Graphics

Receiver box.

●

Reconfigure your DHCP and DNS servers so that the hostname resolves to the IP address of

the correct (first) network interface.

Network Interface binding on the Sender

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 246 247

Žádné komentáře

HP Remote Graphics Software (RGS) Uživatelský manuál Strana 105