HP SN6000 Uživatelský manuál stáhnout pdf (Strana 25)

HP SAN Connection Manager User Guide 25

Removing SAN Connection Manager in Linux

Follow these steps to remove the SAN Connection ManagerSAN Connection Manager software on a

server running Linux.

CAUTION: If the system is booted from your SAN using the QLogic FC HBA driver, use the Linux

uninstallation option cautiously. Your QLogic FC HBA drivers will also be removed from the system, thus

making it un-bootable because the drivers are removed from the Linux initial RAM disk (initrd), the

temporary file system used by the Linux kernel during boot.

1. Insert the installation CD into the CD-ROM drive of the server. The installation CD should mount

automatically in one of the following locations:

/media/cdrom/

/mnt/cdrom/

/media/cdrecorder/

If the installation CD is not mounted automatically, then issue the following commands to mount the CD:

# mkdir -p /mnt/cdrom

# mount /dev/cdrom /mnt/cdrom

2. Change directory to the linux directory. For example, if the installation CD is mounted in

/mnt/cdrom, issue the following command:

# cd /mnt/cdrom/HP_SSCM/linux/

3. Run the install_smb.sh script with the uninstall option as follows:

# ./install_smb.sh --uninstall

This will remove the following components:

•QLogic FC HBA Driver

• HP Array Configuration Utility, if installed

• QLogic SANsurfer agent, QLRemote, if installed

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 161 162

Žádné komentáře

HP SN6000 Uživatelský manuál Strana 25