Hp Storage Mirroring V4.5 Software Uživatelský manuál stáhnout pdf (Strana 23)

3 - 1

Protecting an

Exchange Server

To configure protection for your Exchange servers, you will complete the following steps:

1. Install Exchange on the source server and apply any Exchange service packs or patches. Use the

default installation options for Exchange.

2. Install Exchange on the target, placing it in the same Exchange organization as the source and

verifying that the installation location for the target is the same as the source. Apply any

Exchange service packs or patches. Use the default installation options for Exchange with the

following considerations:

 The target must be a unique installation (that is, two Exchange servers must be available for

a protection pair)

 Logical drive mapping must be the same on the source and target, and must assigned prior

to running the Application Manager

3. Install Storage Mirroring on the source and target Exchange servers. See the Storage Mirroring

Getting Started guide for more information.

4. Install the Application Manager on page 2-1

5. Verify the Exchange environment (recommended) on page 3-1

6. Select a task on page 3-2

7. Select a domain on page 3-2

8. Select source and target servers on page 3-3

9. (Optional) Configure protection settings on page 3-4

10. Validate the Configuration on page 9-1

To protect your Exchange server, you will complete the following steps:

1. Enable protection on page 10-1

2. Monitor protection status on page 10-2

In the event of a failure, you will need to perform some additional tasks. These tasks are described

in Failover, Failback, and Restoration on page 11-1.

Verify the Exchange environment (recommended)

Before you use Application Manager, complete the following tasks to verify that the environment is

properly set up.

1. With both Exchange servers online, use Active Directory Users and Computers to move an

existing user from the source to the target and then back to the original source.

2. Verify that you can create a new user on the target.

3. To verify connectivity, create an Outlook

profile for the new user on a client machine and

connect to the target.

NOTE: If you need to protect any data that is stored on a non-mailbox server role (for example,

SMTP queue data), you will need to configure protection for that data separately. In

addition, you may need to manually update the DNS setting for the client access server

to point to the target site.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 162 163

Žádné komentáře

Hp Storage Mirroring V4.5 Software Uživatelský manuál Strana 23