Hp Tape Library Interface Manager Software Uživatelský manuál stáhnout pdf (Strana 107)

Chapter 5 Troubleshooting 107

Chapter 5

Problem - Solution

This section describes potential problems and solutions. If you are unable to

diagnose and solve a problem using these guidelines, contact an HP service

representative or your sales representative. By using these suggested

procedures, you can determine in advance some of the information that a

service technician will need.

Problem: Drives Not Detected after Power Failure to both the Interface

Manager (IM) and the Library

Before proceeding, make sure the library has completed all power on self tests.

The Interface Manager has no direct communication path to the library.

Consequently, after power is lost to both the IM and the library, the IM does

not know when the drives will be available to be accessed aver SCSI. If the IM

scans the SCSI buses before the drives are ready, it will not find the drives.You

have three options to have the IM re-scan the SCSI buses.

Option 1 - Not Using Telnet or the Web Interface

1. Open the back of the library.

2. Unplug the Interface Manager power cord.

3. Plug the power cord back into the Interface Manager.

Option 2 - Using Telnet

1. Log in as described in Accessing Telnet on page 38.

2. Select [1] to access the Administration menu.

3. Select [4] to restart the entire Interface Manager.

Option 3 - Using the Web Interface

1. Access the Web Administrator as described in Accessing the Web Based

Administrator on page 55.

2. Select the [Operations] tab.

3. Select the [Reboot] page.

4. Click on the [Reboot Interface Manager] button.

5. Supply the administration password.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 137 138

Žádné komentáře

Hp Tape Library Interface Manager Software Uživatelský manuál Strana 107