Hp XP Command View Advanced Edition Software Uživatelský manuál stáhnout pdf (Strana 34)

Registering the load library for LINKLIB and the KTQRYSMS command for

authentication

To register the load library for LINKLIB and the KTQRYSMS command for authentication to enable the

use of CLI commands:

Procedure

1. Concatenate the load library for LINKLIB HPQKLNKT to LNKLST.

You can concatenate by using either of the following methods:

• Static method: Specify the load library for LINKLIB HPQKLNKT in the PROGxx parmlib member

as a dataset concatenated to the LNKLST.

To enable concatenation, you must perform an IPL again.

• Dynamic method: Use the SETPROG LNKLST command to concatenate the load library for

LINKLIB HPQKLNKT to the LNKLST.

If you cannot perform an IPL because the system is running, use this method to concatenate

the load library. However, because performing an IPL will invalidate concatenation, modify

parmlib as defined in the static method, above so the change will continue across an IPL.

2. Register the load library for LINKLIB HPQKLNKT for APF authorization.

You can register by using either of the following methods:

• Static method: Add the load library for LINKLIB HPQKLNKT to the PROGxx parmlib member

as a dataset to be authorized as APF.

To enable registration, you must perform an IPL again.

• Dynamic method: Use the SETPROG APF,ADD command to register the load library as APF

authentication.

If you cannot perform an IPL because the system is running, use this method to perform regis-

tration. However, because performing an IPL will invalidate registration, modify parmlib as

described above in the static method so the change will be available across an IPL.

TIP:

LNKLST has APF authorization by default, so you do not have to perform step 2, if the load

library for LINKLIB HPQKLNKT was concatenated with LNKLST in step 1. Note that there

are exceptions to this rule. For details about APF authorization related to LNKLST, see the

manual

MVS Initialization and Tuning Reference

3. Register the KTQRYSMS command as a TSO/E authorized command.

Add the command name KTQRYSMS to the AUTHCMD section in the IKJTSOxx parmlib member.

To enable registration, you must perform an IPL again. If you use the PARMLIB CHECK (nn)

command and the PARMLIB UPDATE (nn) command, registration can be enabled without

performing an IPL again. For details about the PARMLIB command, see the TSO/E System

Programming Command Reference.

The KTQRYSMS command is a CLI command that is used internally by Smart Manager for

Mainframe to acquire SMS storage group information.

For details about the SETPROG command, see the manual MVS System Commands.

Installation and setup34

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 309 310

Žádné komentáře

Hp XP Command View Advanced Edition Software Uživatelský manuál Strana 34