HP EliteDesk 705 G3 Small Form Factor PC Uživatelský manuál stáhnout pdf (Strana 60)

Front I/O assembly

The front I/O assembly is attached to the front of the chassis with one screw. Push the assembly into the

chassis to remove.

1. Prepare the computer for disassembly (Preparation for disassembly on page 18).

2. Remove the access panel (Access panel on page 19).

3. Remove the front bezel (Front bezel on page 19).

4. Rotate the drive cage to its upright position.

5. From the front of the computer, remove the Torx T15 screw (1) that secures the assembly to the front of

the chassis.

6. Press the tab on the right side of the assembly (2), and then push the assembly into the computer.

7. Rotate the drive cage to its upright position.

8. Disconnect the cables from the system board as follows:

(1) Blue connector labeled FRONT_USB3.1

(2) Yellow connector labeled USB2

(3) Blue connector labeled FRONT AUD

9. Remove the cables from the clips built into the basepan.

52 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 150 151

Žádné komentáře

HP EliteDesk 705 G3 Small Form Factor PC Uživatelský manuál Strana 60