HP EliteDesk 800 G4 Base Model Small Form Factor PC Uživatelský manuál stáhnout pdf (Strana 61)

Optional rear port

The optional rear port is attached to the rear of the chassis with two screws.

To remove the optional rear port:

1. Prepare the computer for disassembly (Preparation for disassembly on page 17).

2. Remove the access panel (Access panel on page 18).

3. Remove the air duct (Air duct on page 51).

4. Disconnect the cable from the system board connector labeled COMA (1).

5. Remove the two hex nut jack screws (2) that secure the port to the rear of the chassis.

6. Remove the port from the computer (3).

To install the optional rear port, reverse the removal procedures.

Optional rear port 53

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 143 144

Žádné komentáře

HP EliteDesk 800 G4 Base Model Small Form Factor PC Uživatelský manuál Strana 61