Hp Parallel Uninterruptible Power System Uživatelský manuál stáhnout pdf (Strana 31)

UPS installation 31

You can install an optional REPO circuit that shuts down the entire parallel system using a single switch. To

install a REPO switch for a parallel system, the selected REPO command (NO or NC) contacts from each UPS

in the system must be in parallel.

To install a REPO switch for a parallel system:

1. Verify that the UPS system is powered down and all power sources are removed. For more information,

see "Powering down the parallel system (on page 73)."

2. Mount the remote REPO switch. HP recommends mounting the REPO switch near the operator's

consoles or near the exit doors. For enclosure dimensions and wiring knockouts, see the REPO switch

manufacturer's installation instructions.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 114 115

Žádné komentáře

Hp Parallel Uninterruptible Power System Uživatelský manuál Strana 31