Hp Parallel Uninterruptible Power System Uživatelský manuál stáhnout pdf (Strana 76)

Communication 76

Pin number Signal name Function Direction from the UPS

— No connection —

GND Signal common (tied to chassis) —

— No connection —

Control terminals

The cables should be connected to the control terminal with a mating connector. Input and output terminals

have a functional isolation from terminal to terminal. They are connected to the UPS chassis through

individual 1 MW resistors.

If using a semiconductor switch type, pay attention to the proper polarity. A relay or other mechanical control

is preferred.

Relay output contacts

WARNING: The relay output contacts must not be connected to any utility connected circuits.

Reinforced insulation to the utility is required. The relay output contacts have a maximum rating of

30 VAC/1 A and 60 Vdc/2 A nominal values.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 114 115

Žádné komentáře

Hp Parallel Uninterruptible Power System Uživatelský manuál Strana 76