Hp Netserver L Server series Uživatelský manuál stáhnout pdf (Strana 31)

Chapter 3 Installing Mass Storage Devices

Figure 3-5. Opening Drive Ejector Arms

2. Remove the drive:

a. Using both hands, grasp the ejector arms and firmly pull the drive out

about an inch to disengage the connection on the backplane.

See Figure 3-6.

b. Wait about 30 seconds for the drive to stop spinning and for the drive

heads to park.

c. Use your hand to support the bottom of the drive, while you slowly pull

the drive straight out. Do not allow the drive to fall.

3. Place the drive in an electrostatic protected container. Do not stack drives.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 145 146

HP Netserver LP 2000r 1
User Guide 1
(1.13 and 1.26 GHz) 1
Audience Assumptions 2
Contents 3
Front Panel 7
LED ICON Description 9
Rear Panel 10
Powering-Up the HP Netserver 12
Sleep States (ACPI) 13
Netserver 15
Replacing the Front Bezel 16
Removing the Top Cover 16
Replacing the Top Cover 17
Air Flow Guide 19
Removing the PCI Card Cage 20
Replacing the PCI Card Cage 21
Boot Priority 25
Hardware Mirroring 26
Top Connector 34
Bottom Connector 34
Installing Additional DIMMs 38
Removing DIMMs 42
IRQ Settings 46
I C Connector 47
Integrated 48
RA Board 48
Connector 48
Removing an Accessory Board 53
Primary Processor (CPU1) 56
Secondary 56
Processor 56
ZIF Lever 59
Terminator 59
Installing the Heatsink 61
(4-Post) 67
Marking Rack Columns 71
Anti-tip Foot 72
Extended 72
Screws (4) 72
(2-Post) 81
Preparing the HP Netserver 86
Mouse, and Power Supplies 93
Release Lever 96
HP Management Solutions 101
DiagTools 102
Setup (BIOS) Utility 102
Accessing the Setup Utility 103
Menu Bar 103
Using the Setup Screens 104
➢Power-On Password 106
➢Hardware Security 106
SCSI Configuration Utility 107
Overview 109
12 Troubleshooting 111
Common Installation Problems 112
Netserver Will Not Power On 113
Chapter 12 Troubleshooting 114
Resetting a Lost Password 116
Hardware Problems 117
CD-ROM Drive Does Not Work 118
SCSI Device Does Not Work 118
Replacing a Battery 119
Introduction 121
Tools Required 123
Rack Configuration Tools 123
Safety Precautions 124
Marking the Columns 125
See Figure 13-5 128
Attaching the Front Bezel 131
Cabling Rack Components 132
A Specifications 135
Appendix A Specifications 136
System Board Layout 138

Komentáře k této Příručce

Žádné komentáře

Hp Netserver L Server series Uživatelský manuál Strana 31

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Hp Netserver L Server series