HP Web Jetadmin Software Uživatelský manuál stáhnout pdf (Strana 188)

c. If HP Web Jetadmin is congured to discover SNMPv3 devices, use the following steps to specify the

SNMPv3 credentials:

TIP: To enable HP Web Jetadmin to discover SNMPv3 devices, go to Tools > Options > Device

Management > Device Discovery > General.

i. Select the SNMPv3 Credentials check box.

ii. In the User name box, enter the user name.

iii. From the Authentication Protocol list, select the protocol.

For third-party devices, the authentication protocol must be MD5 or SHA-1. HP Web Jetadmin

cannot discover third-party devices that do not use these protocols.

iv. In the Authenticated password and Conrm authenticated password boxes, enter the

authenticated password (minimum of 8 characters).

For third-party devices, the authentication password must be in the format of a passphrase with

a minimum length of 8 characters. HP Web Jetadmin cannot discover third-party devices that

have an authentication password that is in the format of a key or that is less than 8 characters.

v. From the Privacy Protocol list, select the protocol.

For third-party devices, the privacy protocol must be DES or AES-128. HP Web Jetadmin cannot

discover third-party devices that do not use these protocols.

vi. In the Private password and Conrm private password boxes, enter the private password

(minimum of 8 characters).

vii. For HP devices, select the HP Device checkbox. HP Web Jetadmin uses Jetdirect for the context

name.

-or-

For third-party devices, clear the HP Device checkbox, and then enter a context name in the box

next to the HP Device checkbox. The context name can be left blank.

d. If Active Directory credentials are required, select the Active Directory Credentials check box, and then

enter the user name, password, and domain in the boxes.

e. To use the global credentials, select the Use global credentials checkbox.

TIP: To dene the global credentials, go to Tools > Options > Shared > Credentials, and then select

the appropriate option.

7. Click the Next button.

8. Use the following steps to schedule the discovery:

NOTE: A scheduled task uses the date and time on the server where HP Web Jetadmin is installed. The

location where the scheduled task runs might not be in the same time zone as the location where the

HP Web Jetadmin server is installed. Consider the potential for date and time dierences when scheduling

tasks.

a. In the Name box, enter a name for this discovery schedule.

b. In the Start time boxes, specify the date and time that this discovery starts.

c. In the Recurrence section, select the option that denes how often this discovery runs, and then

specify the corresponding settings.

d. Click the Next button.

162 Chapter 3 Device Management ENWW

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 491 492

Žádné komentáře

HP Web Jetadmin Software Uživatelský manuál Strana 188