HP MT40 Průvodce řešením problémů stáhnout pdf (Strana 29)

HP Velocity FAQ and Troubleshooting Guide 29

HP Velocity troubleshooting Troubleshooting procedures

Adding an IP address to the policy filter blacklist

To add an IP address to the policy filter blacklist:

1. On the HP Velocity server system, right-click the HP Velocity system tray icon.

2. Select Management.

3. Click Configuration.

4. Select Policy Filters in the navigation tree.

5. In the Blacklist field of the IP Address pane, enter the IP address and netmask, using the

format xxx.xxx.xxx.xxx/xx, and separating each entry with a space.

6. Click Apply.

For more information, see the “Policy Filters (Port & IP)” section of the HP Velocity Server Side

Deployment Guide.

Local IP The local IP address for the protected flow.

Local Port The local TCP or UDP port number for the protected flow. If the port

number is a well-known protocol, the protocol name also appears.

Protocol The protocol (such as TCP or UDP) used by the protected flow.

LiveTCP Indicates whether LiveTCP is protecting the flow. The modes are:

• Protecting: LiveTCP is providing latency mitigation to the flow.

• Inspecting: LiveTCP is in a monitoring state as network conditions have

not been satisfied to provide protection for the flow.

• Off: LiveTCP is not active.

• N/A: LiveTCP is not applicable for the flow.

LiveQ Indicates whether HP Velocity is protecting the flow or monitoring the flow

for packet loss.

TLR The TLR applied to the protected flow as a percentage that HP Velocity will

attempt to achieve.

Encoding The encoding level applied to the protected flow.

Statistic name Description

1 2 ... 24 25 26 27 28 29 30 31

Žádné komentáře

HP MT40 Průvodce řešením problémů Strana 29