HP rp5400 Instalační příručka stáhnout pdf (Strana 14)

Installing Additional Components

Installing Memory

Chapter 1

Installing rp5470 DIMMs

Step 1. Power down and unplug the rp54xx Server.

NOTE DC voltages are present when the server is connected to AC power. Do not attempt to

install or service: CPUs, memory, PSMs, the platform monitor or PCI I/O cards

installed in non-turbo slots (1-6) while DC voltage is present. Failure to observe this

warning may result in damage to the server.

Step 2. Make the top of the server accessible for service.

Step 3. Loosen the captive T-15 screws that hold the top cover in place, then grasp the strap handle, raise

the cover slightly, and pull the cover toward the front of the server to free the cover tabs from the

slots in the chassis. The air baffle will be exposed.

Step 4. Loosen the four (4) captive T-15 screws on the air baffle. Grasp the two handles on the baffle, and

lift and remove the baffle.

Step 5. Observe electrostatic discharge (ESD) precautions.

Step 6. Refer to the following graphic for memory carrier locations.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 83 84

Žádné komentáře

HP rp5400 Instalační příručka Strana 14