HP Vectra XE310 Průvodce řešením problémů stáhnout pdf (Strana 17)

Upgrading and Replacing PC Hardware

Replacing the Floppy Drive

WARNING For your safety, disconnect the power cord and all external cables.

1 Switch off the PC, disconnect the power cord and remove the PC’s side panel and air flow guide (refer

“Removing and Replacing the Side Panel & Air Flow Guide” on page 12).

2 Press the tab on the hard disk drive/floppy disk drive tray and pull the tray out part of the way.

Press here

3 Disconnect all cables at the back of the floppy disk drive and hard disk drive.

4 Remove the drive tray from the PC.

5 Remove the two floppy drive fixing screws (one on either side of the drive tray), noting carefully the

position of these screws.

6 Slide the floppy drive out through the front of the tray.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Žádné komentáře

HP Vectra XE310 Průvodce řešením problémů Strana 17