HP Visualize c3000 Manuál s instrukcemi stáhnout pdf (Strana 143)

Chapter 5 143

Changing Your Computer Hardware Conﬁguration

Hard Disk Drives

4. Insert the T-15 Torx Hard Disk Mounting Screws through the rubber

mounting grommets and into the screw holes located on the sides of

the hard disk drive. See Figure 5-39. You should tighten these screws

using 6 inch-pounds of torque. Note that in order to screw the T-15

Torx screws into the sides of the hard disk drive you will have to have

a T-15 Torx driver that is long enough to ﬁt through the access holes

on the sides of the hard disk drive bracket.

Figure 5-39 Inserting the Hard Disk Drive

5. Slide the assembly into its hard drive slot, and push inward on the

release lever until the front of the hard disk drive bracket is ﬂush

with the system unit and the lever snaps closed. The front panel

should now be replaced as explained in the section “Closing the

System Unit Front Panel” in this chapter.

Hard Disk

Drive Bracket

Mounting

Grommet

(do not remove)

Hard Disk

Drive

T-15 Torx

Shoulder

Screw

Hard Disk Drive

Mounting Screw

Access Hole

(there are four of

them)

(there are

four of them)

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 245 246

Žádné komentáře

HP Visualize c3000 Manuál s instrukcemi Strana 143