HP 200 Unified Threat Management (UTM) Appliance Series Rychlý návod stáhnout pdf (Strana 103)

When multiple users configure a setting in system view, only the last configuration applies.

To configure the maximum number of concurrent users:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Configure the maximum

number of concurrent users.

configure-user count number

By default, up to two users can

perform operations in system view

at the same time.

Configuring the exception handling method

You can configure the device to handle system exceptions in one of the following methods:

• reboot—The device automatically reboots to recover from the error condition.

• maintain—The device stays in the error condition so you can collect complete data, including error

messages, for diagnosis. In this approach, you must manually reboot the device.

To configure the exception handling method:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Configure the exception

handling method for the

system.

system-failure { maintain | reboot }

By default, the system uses the

reboot method when an exception

occurs.

Rebooting the device

You can reboot the device in one of the following ways to restore the device from an error condition or

place the new software of the device into effect:

• Reboot the device immediately in the Web or at the CLI.

• At the CLI, schedule a reboot to occur at a specific time and date or after a delay.

• Power off and then power on the device. This method might cause data loss, and is the

least-preferred method.

Reboot in the Web or at the CLI enables easy remote device maintenance.

Rebooting the firewall in the Web interface

CAUTION:

• Rebooting the device results in service interruption.

• To avoid configuration loss, save the configuration before rebooting the device. For how to save the

running configuration, see

System Management and Maintenance Configuration Guide

1. Select Device Management > Reboot from the navigation tree.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 149 150

Komentáře k této Příručce

Žádné komentáře

HP 200 Unified Threat Management (UTM) Appliance Series Rychlý návod Strana 103

Komentáře k této Příručce

Související produkty a manuály pro Software HP 200 Unified Threat Management (UTM) Appliance Series