HP PROCURVE 6120 Uživatelský manuál stáhnout pdf (Strana 203)

100

101

9-14

Time Protocols

SNTP: Viewing, Selecting, and Configuring

Changing the SNTP Poll Interval.

For example, to change the poll interval to 300 seconds:

ProCurve(config)# sntp poll-interval 300

Changing the Priority. You can choose the order in which configured

servers are polled for getting the time by setting the server priority.

For example, to set one server to priority 1 and another to priority 2:

ProCurve(config)# sntp server priority 1 10.28.22.141

ProCurve(config)# sntp server priority 2

2001:db8::215:60ff:fe79:8980

Disabling Time Synchronization Without Changing the SNTP

Configuration. The recommended method for disabling time synchroniza-

tion is to use the timesync command.

For example, suppose SNTP is running as the switch’s time synchronization

protocol, with Broadcast as the SNTP mode and the factory-default polling

interval. You would halt time synchronization with this command:

ProCurve(config)# no timesync

If you then viewed the SNTP configuration, you would see the following:

Syntax:

sntp poll-interval < 30..720 >

Specifies how long the switch waits between time polling

intervals. The default is 720 seconds and the range is 30 to

720 seconds. (This parameter is separate from the poll inter-

val parameter used for Timep operation.)

Syntax: sntp server priority <1 - 3> <ip-address>

Specifies the order in which the configured servers are polled

for getting the time. Value is between 1 and 3.

Note: Both IPv4 and IPv6 addresses can be entered. For more

information about IPv6 addresses, see the “IPv6 Configura-

tion Guide” for your switch.

Syntax: no timesync

Halts time synchronization without changing your SNTP

configuration.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 588 589

Komentáře k této Příručce

Žádné komentáře

HP PROCURVE 6120 Uživatelský manuál Strana 203

Komentáře k této Příručce

Související produkty a manuály pro Software HP PROCURVE 6120