HP PROCURVE 6120 Uživatelský manuál stáhnout pdf (Strana 405)

100

101

A-31

File Transfers

Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation

Copying Command Output to a Destination Device

For example, to use Xmodem to copy the output of show config to a serially

connected PC:

Figure A-11. Example of Sending Command Output to a File on an Attached PC

Note The command you specify must be enclosed in double-quote marks.

Copying Event Log Output to a Destination Device

For example, to copy the event log to a PC connected to the switch:

Syntax:

copy command-output < “cli-command” > tftp < ip-address > < filepath-

filename >

copy command-output < “cli-command” > usb < filename >

copy command-output <“cli-command”> xmodem

These commands direct the displayed output of a CLI

command to a remote host, attached USB device, or to a serially

connected PC or UNIX workstation.

At this point, press

[Enter] and start the

Xmodem command

sequence in your

terminal emulator.

Indicates the operation is finished.

Syntax: copy event-log tftp < ip-address > < filepath_filename >

copy event-log usb < filename >

copy event-log xmodem <filename>

These commands copy the Event Log content to a remote host,

attached USB device, or to a serially connected PC or UNIX

workstation.

1 2 ... 400 401 402 403 404 405 406 407 408 409 410 ... 588 589

Komentáře k této Příručce

Žádné komentáře

HP PROCURVE 6120 Uživatelský manuál Strana 405

Komentáře k této Příručce

Související produkty a manuály pro Software HP PROCURVE 6120