HP Value 2D Wireless Scanner Uživatelský manuál stáhnout pdf (Strana 18)

Connecting the base station

You can connect the base station to a terminal, PC, or other host device. Turn off the host before connection

and consult the manual for that equipment (if necessary) before proceeding. Connect the interface cable

before applying power to the base station.

NOTE: The scanner can also be powered by the terminal. When powered by the terminal, the battery

charger is automatically set as slow charge.

For some specific interfaces or hosts or lengths of cable, the use of an external power supply may be

recommended for full recharging capability (refer to

Technical specifications on page 35 for more details).

Base station connection and routing

1. Remove the rubber cable stopper (1) from the bottom of the base station.

2. Securely plug the power cable (2) and interface cable (3) connectors into their respective ports in the

underside of the base station.

Figure 4-4 Connecting Cables

3. After the cables are plugged in, reinsert the cable stopper.

Figure 4-5 Reinserting Cable Stopper

12 Chapter 4 Setting up and using the scanner

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Žádné komentáře

HP Value 2D Wireless Scanner Uživatelský manuál Strana 18