HP Value 2D Wireless Scanner Uživatelský manuál stáhnout pdf (Strana 8)

OPOS driver

The scanner by default is shipped in the human interface device (HID) keyboard emulation mode. In order to

use the barcode scanner with OLE for Retail POS (OPOS) drivers the scanner must be put into USB COM (OPOS)

mode.

For your convenience the bar code to put the scanner into USB COM (OPOS) mode or into HID keyboard

emulation are located in this document. Refer to the Programming Reference Guide (PRG) for complete list of

barcodes. The document can be found on the HP Point of Sale System Software and Documentation CD that

comes with the scanner or the softpaq that is located on the HP support web site.

Scan the following bar code (USB COM OPOS) in order to put the scanner into the mode to be used with the

OPOS drivers.

Figure 1-5 SB COM (OPOS)

Carriage return

Scan the following bar code to set the scanner back to the factory defaults.

Figure 1-6 Set Base Defaults

NOTE: Scanning the “Set Base Defaults” bar code does not change the interface type.

If a carriage return is required after each scanned bar code, scan the following bar codes in order:

Figure 1-7 Enter Programming Mode

2 Chapter 1 Quick setup

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Žádné komentáře

HP Value 2D Wireless Scanner Uživatelský manuál Strana 8