Hp NetRAID-4M Controller Uživatelský manuál Strana 27

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 336
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 26
3-3
Working with Controllers
The CLI allows you to open a controller in the following modes:
Read/write
Read-only
Snapshot
Modes of Opening and Closing a Controller
The CLI allows you to open and close a controller on the supported
operating system using the following modes:
Read/write
Read-only
Snapshot
The following sections describe how to open a controller in these
three modes and how to close a controller.
Opening a Controller in Read/Write Mode
To open a controller in read/write mode on the supported operating
system, use the open command, as in the following example.
HPN0> open HPN0
Executing: open "HPN0"
Opening a Controller in Read-only Mode
To open a controller in read-only mode on the supported operating
system, use the open command with the /readonly switch, as in
the following example.
HPN0> open /readonly=TRUE HPN0
Executing: open /readonly=TRUE "HPN0"
If after opening a controller in read-only mode, you decide you want
write access to that controller, you can do so without closing and
reopening the controller. Simply specify the open command with
the /readonly switch set to FALSE, as in the following example:
HPN0> open /readonly=FALSE HPN0
Executing: open /readonly=FALSE "HPN0"
Zobrazit stránku 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 335 336

Komentáře k této Příručce

Žádné komentáře