Hp NetRAID-4M Controller Uživatelský manuál stáhnout pdf (Strana 295)

13-7

Working with Tasks

Controller Tasks

TaskId Function Done% Container State Specific1 Specific2

------ -------- ------- --------- ----- --------- ---------

No tasks currently running on controller

To start a task, use the container create mirror command, as

in the following example. In the example, the container create

mirror command starts a mirror set create (MCR) task and a

container scrub (MSC) task.

HPN0> container create mirror 0 (3,0.0)

Executing: container create mirror 0 (CHANNEL=3, ID=1,LUN=0)

After executing the container create mirror command, use

the task list command to verify that the task is running, as in the

following example. In the example, the Function column indicates

Scrub, which means that the container scrub task is executing while

the mirror set is being created.

HPN0> task list

Executing: task list

Controller Tasks

TaskId Function Done% Container State Specific1 Specific2

------ -------- ------- --------- ----- --------- ---------

108 Scrub 46.0% 00 RUN 00000000 00000000

Stopping Tasks

The CLI’s task stop command allows you to terminate one or all

tasks that are running on a controller.

This section provides an example that describes how to stop a task

running on a controller.

Before stopping a task, use the task list command to display

information about all tasks running on a controller, as in the

following example. In the example the Ta s k I D column indicates 106,

which means that task 106 is running on a controller, and the

Done% column indicates 63.5%, which means that the task is 63.5%

complete.

1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 335 336

Žádné komentáře

Hp NetRAID-4M Controller Uživatelský manuál Strana 295