Hp ProLiant ML350p Gen8 Server Uživatelský manuál stáhnout pdf (Strana 86)

Hardware options installation 86

• If two fans fail, then the server shuts down.

IMPORTANT: Fan louvers must be present for the redundant configuration. Without the louvers,

all four fans are nonredundant.

NOTE: If your system is already installed with four fans, store the fan that is included in this kit as

a spare.

Installing a hot-plug redundant fan

1. Do one of the following:

o For tower models, open and remove the bezel ("Remove the tower bezel" on page 21).

o For rack models, if installed, remove the security bezel (on page 21).

2. Power down the server (on page 20).

3. Remove all power:

a. Disconnect each power cord from the power source.

b. Disconnect each power cord from the server.

4. Do one of the following:

o For tower models, place the server on a flat, level surface with the access panel facing up.

o For rack models, extend the server from the rack (on page 24).

5. Remove the access panel (on page 23).

6. Remove all the fans and fan blanks.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 144 145

Žádné komentáře

Hp ProLiant ML350p Gen8 Server Uživatelský manuál Strana 86