Hp ProLiant SL2500 Scalable System Uživatelský manuál Strana 91

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 117
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 90
CLI commands 91
Set SNMP contact
Command:
SET SNMP CONTACT "<sysContact>"
Description:
Sets the MIB II sysContact field.
Set SNMP location
Command:
SET SNMP LOCATION "<sysLocation>"
Description:
Sets the MIB II sysLocation field.
Set SNMP trapdest
Command:
SET SNMP TRAPDEST <<ip_addresses>|NONE>
Description:
o Sets the IP addresses where SNMP traps are sent.
You can set up to four SNMP trap destinations. For example, enter:
SET SNMP TRAPDEST x.x.x.x y.y.y.y z.z.z.z a.a.a.a
If you specify NONE, then no trap destinations are set. For example, enter:
SET SNMP TRAPDEST NONE
o HP APM supports the following SNMP traps:
NOTE: SNMP traps denoted by an * are not supported on the HP ProLiant s6500 Chassis.
cpqRackNameChanged
cpqRackEnclosureRemoved
cpqRackEnclosureInserted
cpqRackEnclosureFanRemoved *
cpqRackEnclosureFanInserted *
cpqRackEnclosureFanFailed
cpqRackEnclosureFanOK
cpqRackPowerSupplyFailed
cpqRackPowerSupplyOK
cpqRackPowerSupplyRemoved
cpqRackPowerSupplyInserted
cpqRackServerBladeRemoved
Zobrazit stránku 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 116 117

Komentáře k této Příručce

Žádné komentáře