HP VMA-series Memory Arrays Uživatelský manuál stáhnout pdf (Strana 11)

f. Enter the correct COM port number as the serial port to be used, and click the Serial

settings tab in the left Category section. The serial (PuTTY) configuration window below

appears.

g. You must set the serial settings as follows:

• Baud Rate: 9600 (this might change to 115200 with future versions of array firmware)

• Bits: 8

• Stop Bits: 1

• Parity: None

• Carrier Detect: None (if settable)

• Flow Control: Xon/Xoff

h. To establish the serial communication with the VMA Array, click Open. The Terminal

window appears. You might need to press Enter to get the login prompt on the serial

port. If it is not responding, try setting baud rate to 115200 and try again.

Configuring the Laptop to communicate with the VMA Array 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Žádné komentáře

HP VMA-series Memory Arrays Uživatelský manuál Strana 11