
Removal and replacement procedures 24
4.
Release the latches and lift the DC filter module away from the system board while pushing the
power connector into the chassis.
To replace the component, reverse the removal procedure.
Power button/LED board
To remove the component:
1. Power down the server blade and remove it from the server blade enclosure ("Server blade
preparation" on page 11).
2. Remove the access panel ("Access panel" on page 12).
3. Remove any hot-plug SCSI hard drives or hard drive blanks ("Hard drives" on page 12).
4.
5. Disconnect the power button/LED cable from the rear left side of the power button/LED board.
6. Slide the power button/LED board toward the left outside edge of the chassis.
7. Tilt the front edge of the power button/LED board down until the keyholes on the rear of the board
clear the alignment pins.
With a T-6 Torx screwdriver, remove the two retaining screws from the bottom of the chassis.
Komentáře k této Příručce