HP 2000CP 2500CP Uživatelský manuál Strana 131

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 348
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 130
5-10 Service Calibrations
HP DesignJet CP Series Printers
C03. Line Sensor
The purpose of this calibration is to calibrate the intensity of the line sensor
in the carriage PCA. An incorrect calibration can result in edge-detection
failures during media loading and incorrect reading of prints that are used
for alignment or calibration.
This calibration also identifies which type of Line Sensor has been installed
and stores this information in the EEROM.
Perform the line sensor calibration whenever the:
Edge detect procedure fails during media loading.
Carriage is disassembled or replaced.
Electronics Module is replaced.
Banding is detected in prints.
Misalignment between colors is detected.
There is a color consistency problem between prints.
Load white media before performing this calibration.
Perform the Line Sensor Calibration as follows:
MAKE SURE THAT THE WINDOW IS CLOSED BEFORE YOU
PERFORM THIS CALIBRATION.
REPLACE THE LENS COVER BEFORE YOU PERFORM THIS
CALIBRATION IN ORDER TO PREVENT ANY AEROSOL
PROBLEMS.
1 In the Calibrations submenu, scroll to “C3 Line Sensor” and press Enter.
Calibrations
C3 Line Sensor
2 If media is not loaded the calibration will stop and the message “Load
Media” will be displayed on the front-panel. Load media in order to
continue the calibration.
3 While the Calibration is being performed, a row of “***” will be displayed
on the front-panel.
4 Once the Calibration is completed, a message similar to the following is
displayed on the front-panel.
Green: I:8.0 O: 984
Blue: I:10.0 T:0 C:2
Zobrazit stránku 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 347 348

Komentáře k této Příručce

Žádné komentáře