HP 2000CP 2500CP Uživatelský manuál stáhnout pdf (Strana 269)

8-48 Removal and Installation

HP DesignJet CP Series Printers

Cutter Assembly (Only Applicable to

HP DesignJets 2500CP and 2000CP)

Refer to figure 17A  page 8-49

Removal



Switch off the printer and remove the power cord.

1. Remove the following:

1. Right Hand Cover  page 8-21.

2. Remove the window.

3. Move the Carriage Assembly to the right.

4. Remove the stopper (item 1) located on the right end of the overdrive

assembly.

5. Remove the cutter assembly (item 2) from the slider rod by sliding it to

the left and pulling it off the rear bushing (item 3).

Installation

Note: Make sure you install the front wheel of the media cutter

under the lip of the starguard assembly.

1. Install the cutter assembly (item 2) onto the rear bushing (item 3) and

slide to the left. To obtain the correct position so that the cutter assembly

moves easily into position, you may have to move the cutter wheel (item

4) (which is sprung loaded).

2. Install the stopper (item 1) located on the right end of the overdrive

assembly onto the overdrive assembly.

3. Install the following:

2. Right Hand Cover  page 8-21.

4. Install the window.

5. Install the power cable and turn the printer on in service mode.

6. Perform D10 Cutter Service Test  page 4-24

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 347 348

Žádné komentáře

HP 2000CP 2500CP Uživatelský manuál Strana 269